Page 1 of 1

How to adjust program?

Posted: Mon Mar 06, 2017 12:43 am
by whay
Good afternoon~brothers :D I'm coming again.Would you like to know which question I brought? :dance: OK, let's go into the subject.
I learn NRF24L01 not long ago.Recently I am confusing about this question a long time when I’m adjusting program.I hope I can find the answer from this forum.
I send the program according to the adjusting way--disability response,disabled automatic retransmission and receive channel 0 in the disability. If it can send successfully the STATUS should be 0*2e (46), there are not problem.
However! ! The another fifo_status should be 0*11,but here just 0*01, what mean that TX_FIFO is no empty...so I add spi_rw_reg(flush_tx,0) which set before delivery mode when I sent the program.II have try it even add it in the main function, , , , , , Unfortunately,It’s always 0*01.I have no choice. What I can do is post it to the forum and I hope there are manipulators to help me. :doh:

Thank you for taking time to reading my questions,all your advice will be appreciated!
Wishes!

http://www.kynix.com

Re: How to adjust program?

Posted: Thu Mar 09, 2017 7:12 pm
by whay
Nobody can solve this question ? OK...I have no time to solve it before I handed up my homework...

Re: How to adjust program?

Posted: Thu Mar 16, 2017 5:55 am
by Valen
Your first message is too dificult to understand. It seems to have been translated and that didn't help.

Also, you don't show your code, so how are we supposed to suggest alternative solutions.

Last, what's up with that last link? An attempt at advertising?