- Thu Mar 26, 2015 6:31 pm
#180732
I just received this part and am trying to figure out the power wiring. The breakout pins called "VCC" and "5V" I think are tied together and map to what Atmel calls "VCC" and "AVCC"?
The breakout pin called "3.3V" is the output of the onboard 3.3V regulator?
The PDF schematic (http://dlnmh9ip6v2uc.cloudfront.net/dat ... ut-v11.pdf) shows an SJ1 "Power Select". I don't see that physically on this board. Where is this?
I just will provide 5V to the "5V" and "VCC" pins.
Thank you.
The breakout pin called "3.3V" is the output of the onboard 3.3V regulator?
The PDF schematic (http://dlnmh9ip6v2uc.cloudfront.net/dat ... ut-v11.pdf) shows an SJ1 "Power Select". I don't see that physically on this board. Where is this?
I just will provide 5V to the "5V" and "VCC" pins.
Thank you.