- Sat Aug 18, 2012 5:48 am
#148660
i have a USB to uart loader with the same chip (silabs 2102)as the sparkfun breakout but its not the ftdi version but from off ebay .
i keep getting a non snyc error message when trying to load a sketch (a check shows it to be a common error )
error is avrdude: stk500_getsync(): not in sync: resp=0x00
is this because the pro mini is tricky to load a sketch to ?
i cant find much on the pro mini feedbacks
i keep getting a non snyc error message when trying to load a sketch (a check shows it to be a common error )
error is avrdude: stk500_getsync(): not in sync: resp=0x00
is this because the pro mini is tricky to load a sketch to ?
i cant find much on the pro mini feedbacks