- Mon Oct 18, 2010 7:10 pm
#111675
Hey
I just bought a pocket AVR programmer and I'm trying to figure out how to wire it to the Serial Controlled Motor Driver
http://www.sparkfun.com/commerce/produc ... ts_id=9825
http://www.sparkfun.com/commerce/produc ... ts_id=9571
using the broken out pins of the Atmega 328P chip so that I can make changes to the firmware.
The broken out pins on the motor driver are GND, 5V, ADC 7, ADC 6 PC 5, PC 4. Which pins correspond to the Programmer?
Any ideas?
Thanks.
I just bought a pocket AVR programmer and I'm trying to figure out how to wire it to the Serial Controlled Motor Driver
http://www.sparkfun.com/commerce/produc ... ts_id=9825
http://www.sparkfun.com/commerce/produc ... ts_id=9571
using the broken out pins of the Atmega 328P chip so that I can make changes to the firmware.
The broken out pins on the motor driver are GND, 5V, ADC 7, ADC 6 PC 5, PC 4. Which pins correspond to the Programmer?
Any ideas?
Thanks.