PCB for 4x4 LED Button Pad

PCB for 4x4 LED Button Pad#18845

By maokh - Wed Sep 13, 2006 11:29 am

- Wed Sep 13, 2006 11:29 am #18845

I would be interested in a bare PCB for the 4x4 LED button pad. It would be nice if the PCB had holes for RGB LED's, much like the image you have with the button pad.

#18850

By rblue - Wed Sep 13, 2006 2:25 pm

- Wed Sep 13, 2006 2:25 pm #18850

Maokh -- I was looking at the Simon game today and thinking exactly the same thing.

Hi Sparky, on the product page for the 4x4 rubber button pads...
http://www.sparkfun.com/commerce/produc ... ts_id=7835

... you seem to show a PCB just like Maokh is describing...
http://www.sparkfun.com/commerce/images ... -Pad-5.jpg

If I'm reading picture that right, it has your name on it and is labelled "ButtonPad Breakout"

Are you planning on selling this? Could be a lot of fun and make playing with these pads, Monome-style, much easier

Richard

#18970

By KamPutty - Fri Sep 15, 2006 1:02 pm

- Fri Sep 15, 2006 1:02 pm #18970

Count me in for a few!

~Kam (^8*

--
"Before you criticize someone, you should walk a mile in their shoes.
That way, when you criticize them, you're a mile away and you have their shoes."

#19307

By intellijel - Thu Sep 21, 2006 3:00 pm

- Thu Sep 21, 2006 3:00 pm #19307

yeah I plan to build my own Monome. It would be an advantage to buy pre-made pcbs for the button contact pads (not sure if home etching is good enough for this type of thing).

If they were 4x4 grids (like the PCBs shown in the photos for the 4x4 button pads) and they could be tiled to make larger grids then they would be perfect.

You could use boards from the www.ucapps.de MidiBox project (1xcore, 2xdin and 2xdout +MIOS128) for the hardware.

SparkFun Forums