- Wed Sep 06, 2006 10:01 pm
#18502
Hi,
I have a SKU#: PCB-FT232RL breakout board and have run into a problem.
I am trying to interface it to some 5V logic and have realised that the VCCIO is connect on the PCB to the 3.3V pin. Worse than that I can't get to the track to cut it.javascript:emoticon('')
Crying or Very sad
It may be a good idea to have a jumper so that VCCIO may ve connect to 5V or 3.3V.
Or at least expose the track plus a via so that it can be rewired.
Cheers,
Peter.
I have a SKU#: PCB-FT232RL breakout board and have run into a problem.
I am trying to interface it to some 5V logic and have realised that the VCCIO is connect on the PCB to the 3.3V pin. Worse than that I can't get to the track to cut it.javascript:emoticon('')
Crying or Very sad
It may be a good idea to have a jumper so that VCCIO may ve connect to 5V or 3.3V.
Or at least expose the track plus a via so that it can be rewired.
Cheers,
Peter.