SparkFun Electronics Forum

I purchased the microview spinoff :

https://www.sparkfun.com/products/13003

I'm trying the SPI portion, but with no luck.
I Always get a scrambled screen.

With I2C it works without a problem.
I tried it on an Arduino and a Raspberry.

All my connections seem to be right. What else can I check?

I use the code that's provided on your webpage of this breakout.

Did you change the solder jumpers to put it in SPI mode as indicated in the hookup guide?
https://learn.sparkfun.com/tutorials/mi ... okup-guide

yes and I checked them with a multimeter