- Wed Apr 01, 2015 8:04 pm
#180886
Just after a bit of help.
I'm using the Microview in the USB Microview programmer - it fired up with the demo when first plugged in.
The problem is I get the following error message in the Arduino IDE 1.6.2:
Error Compiling:
Arduino: 1.6.2 (Windows 7), Board: "Arduino Uno"
Build options changed, rebuilding all
MicroViewDemo.ino:18:23: fatal error: MicroView.h: No such file or directory
compilation terminated.
Error compiling.
I have followed the IDE installation instructions, the FTDI Driver instructions, set the board to Arduino Uno and identified the Com port using Device manager (Windows 7)
Other IDE settings: Programmer = AVRISP MKII (not set by me) and baud rate 115200 (win com port set to same) Tried 9600 baud also)
The Time and Microview-master libraries are showing under sketchbook and examples.
I can't seem to get anything to compile or upload. Tried HelloWorld sketch - same result.
I get nothing on the Microview now. USB programmer has a constatnt LED.
Hope someone can help. Thanks
I'm using the Microview in the USB Microview programmer - it fired up with the demo when first plugged in.
The problem is I get the following error message in the Arduino IDE 1.6.2:
Error Compiling:
Arduino: 1.6.2 (Windows 7), Board: "Arduino Uno"
Build options changed, rebuilding all
MicroViewDemo.ino:18:23: fatal error: MicroView.h: No such file or directory
compilation terminated.
Error compiling.
I have followed the IDE installation instructions, the FTDI Driver instructions, set the board to Arduino Uno and identified the Com port using Device manager (Windows 7)
Other IDE settings: Programmer = AVRISP MKII (not set by me) and baud rate 115200 (win com port set to same) Tried 9600 baud also)
The Time and Microview-master libraries are showing under sketchbook and examples.
I can't seem to get anything to compile or upload. Tried HelloWorld sketch - same result.
I get nothing on the Microview now. USB programmer has a constatnt LED.
Hope someone can help. Thanks