SparkFun Forums 

Where electronics enthusiasts find answers.

General MicroView Support area - You have questions, find your answers here.

Moderators: Help@GeekAmmo, marcus@geekammo

By developer69
#180258
Double checked everything, I can see when I plug in Microview, I get Com2.
I make sure IDE is set to Com2.
Program will veryify and compile.
But when I do the upload, I get the following error:
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x01avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0x01avrdude: stk500_recv(): programmer is not responding
.
.
.
By Help@GeekAmmo
#180293
Hi,

1. Have you selected the board as Arduino UNO or MicroView?

2. If you have selected the right board, could you try with the latest FTDI driver please?

Cheers
JP
By Moses
#180811
Getting the same problem and I have selected the board as the UNO. After installing the FTDI driver I have a COM1 port that only shows up when the microview is plugged in so I don't think its one of those two problems. My error looks like

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0xae
By Help@GeekAmmo
#180893
Hi Moses,

Can you contact SparkFun customer service quoting this thread and get RMA organized for you please?

Cheers
JP