SparkFun Forums 

Where electronics enthusiasts find answers.

General MicroView Support area - You have questions, find your answers here.

Moderators: marcus@geekammo, Help@GeekAmmo

By developer69
#180258
Double checked everything, I can see when I plug in Microview, I get Com2.
I make sure IDE is set to Com2.
Program will veryify and compile.
But when I do the upload, I get the following error:
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x01avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0x01avrdude: stk500_recv(): programmer is not responding
.
.
.
By Moses
#180811
Getting the same problem and I have selected the board as the UNO. After installing the FTDI driver I have a COM1 port that only shows up when the microview is plugged in so I don't think its one of those two problems. My error looks like

avrdude: stk500_recv(): programmer is not responding

avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0xae