Hi Doomcuroe,
The default Arduino's blink will not run on MicroView because MicroView does not have an LED connected to D13. You can add a LED and 330 ohm resistor to D3 and change the Blink sketch's led pin to 3 or alternatively you can use the display to blink.
If you have codebender, please click the link below to run
https://codebender.cc/sketch:40072?board=MicroView
or cut and paste the code below to your Arduino IDE.
Code: Select all#include <MicroView.h>
/*
MicroView Blink
Draw a circle for one second, then off for one second, repeatedly.
This example code is in the public domain.
*/
// the setup routine runs once when you press reset:
void setup() {
uView.begin();
uView.clear(PAGE);
}
// the loop routine runs over and over again forever:
void loop() {
uView.circleFill(32,24,10,WHITE,NORM);
uView.display();
delay(1000); // wait for a second
uView.circleFill(32,24,10,BLACK,NORM);
uView.display();
delay(1000); // wait for a second
}