- Sun Jun 03, 2018 8:47 am
#199350
I want to use this circuit with 12vdc instead of 24.
So, I want my output(right side) to be 12vdc with the
variable milliamps, based on the microcontroller input.(left side)
Can anyone explain which resistors may need to be changed
to make this happen? (Or any other changes)
This is way past blinking the led and I’m a bit lost here.
I want to at least have some idea before I start to
take measurements and make things hot and smokey.
Thanks.
(I think it will work just the way it is, but I'm not sure)
So, I want my output(right side) to be 12vdc with the
variable milliamps, based on the microcontroller input.(left side)
Can anyone explain which resistors may need to be changed
to make this happen? (Or any other changes)
This is way past blinking the led and I’m a bit lost here.
I want to at least have some idea before I start to
take measurements and make things hot and smokey.
Thanks.
(I think it will work just the way it is, but I'm not sure)
You do not have the required permissions to view the files attached to this post.