Thing Dev Failed AT Commands

General project discussion / help
Did you make a robotic coffee pot which implements HTCPCP and decafs unauthorized users? Show it off here!

Moderator: phalanx

Post Reply
Posts: 1
Joined: Tue Aug 08, 2017 10:59 am

Thing Dev Failed AT Commands

Post by jack_jack » Tue Aug 08, 2017 11:10 am


I recently purchased a Thing Dev Board and am experiencing some problems bringing it up. I have it connected to my PC via its micro USB cable, however upon entering AT commands into my serial terminal, I receive no response. I have the baud rate set to 115200 which I understand to be the Thing's default baud rate with carriage return and line feed also included.

Am I missing something simple?

Thank you

Post Reply