Touch sensitive guitar volume pot
Posted: Tue Aug 01, 2017 3:28 pm
Hi,
I've been wanting to add a touch sensitive volume strip to a guitar project but running into some troubles, Here's the standard wiring diagram that's currently used:
http://2.bp.blogspot.com/-9cBXOSncB...V ... -Split.png I'm thinking of using one of these for the controller:
https://www.sparkfun.com/products/8680? ... 1501520143 This is all good and well but it only goes upto 10K Ohms and most guitar Pots are between 250K and 500K so I would need to put something in the circuit for the soft pot to feed into, I've been looking at digital Pots that the soft pot can control but this might not be the best road to go down...
Do you think an arduino would be useful? any other good ideas?
Cheers
I've been wanting to add a touch sensitive volume strip to a guitar project but running into some troubles, Here's the standard wiring diagram that's currently used:
http://2.bp.blogspot.com/-9cBXOSncB...V ... -Split.png I'm thinking of using one of these for the controller:
https://www.sparkfun.com/products/8680? ... 1501520143 This is all good and well but it only goes upto 10K Ohms and most guitar Pots are between 250K and 500K so I would need to put something in the circuit for the soft pot to feed into, I've been looking at digital Pots that the soft pot can control but this might not be the best road to go down...
Do you think an arduino would be useful? any other good ideas?
Cheers