SparkFun Forums 

Where electronics enthusiasts find answers.

General project discussion / help
Did you make a robotic coffee pot which implements HTCPCP and decafs unauthorized users? Show it off here!
By edencakir
#191770
Hello everyone! I’m Enes and am hoping some of you folks may help me. I have this project for my graduation and I just wanted to be 100% sure before sending it to China for manufacturing - its my first time with PCBs :shock: . It takes 3 weeks to arrive my country therefore I don’t have time to test it, I only got one shot. My prototype works perfectly on breadboard. This is the dropbox link to my BRD files and some screenshot for you guys to check it real quick: https://www.dropbox.com/sh/05sbwndrdl5t ... t1Hka?dl=0

I have few questions below, and I really do appreciate if you download them and control it.

1- Transmission traces between FT232 and Atmega328 are not short traces. Are these traces going to cause any trouble? :doh:
2- Did I place the decoupling capacitors correctly in my layout?
3- Is 16mil drill size too small for manufacturing?
4- Do I need to add a diode between LM3940 and ESP8266-1 ?

Thanks a lot and have a great forum. :dance: