18F25K20 on change interrupt  [SOLVED]

Find out how to setup your programmer's software and how to solve many common problems.

Moderator: phalanx

18F25K20 on change interrupt

Postby Nikola010 » Wed Jun 28, 2017 8:10 am

When i configure on port change interrupt, first time when it happens, it keeps running into interrupt over and over again. The moment it comes into main program interrupt happens again without any change on port. Why is this happening?
Code: Select all
void interrupt(){
      INTCON.RBIF = 0;
      PORTC.RC0 = !PORTC.RC0;
      PORTC.RC1 = !PORTC.RC1;
void main() {
        OSCCON.IRCF0 = 1;
     OSCCON.IRCF1 = 1;
     OSCCON.IRCF2 = 1;
     OSCCON.SCS1 = 0;
     OSCCON.SCS0 = 0;

        TRISB = 255;
        TRISC = 0;
        PORTC = 0;
        PORTC.RC0 = 1;
        PORTC.RC0 = 0;
        PORTC.RC0 = 1;
        INTCON.RBIE = 1;
        INTCON.RBIF = 0;
        IOCB = 255;
        INTCON2.RBIP = 1;
        INTCON.GIE = 1;

Posts: 1
Joined: Wed Jun 28, 2017 8:07 am

Re: 18F25K20 on change interrupt  [SOLVED]

Postby phalanx » Thu Jun 29, 2017 5:29 am

Hi Nikola,

Your answer can be found in section 10.3.2 of the datasheet. Basically you need to do a read or write to PORTB to clear the mismatch status. The PIC keeps track of the prior value of the interrupt on change pins for the purpose of generating the interrupt and a read or write to the port will update their current state. If the mismatch still exists when you exit your ISR, the PIC will immediately interrupt again due to it thinking you had a change on one of your pins.
The user, in the Interrupt Service Routine, can clear the interrupt in the following manner:

a) Any read or write of PORTB to clear the mismatch condition (except when PORTB is the source or destination of a MOVFF instruction).

b) Clear the flag bit, RBIF.

A mismatch condition will continue to set the RBIF flag bit. Reading or writing PORTB will end the mismatch condition and allow the RBIF bit to be cleared. The latch holding the last read value is not affected by a MCLR nor Brown-out Reset. After either one of these Resets, the RBIF flag will continue to be set if a mismatch is present.

User avatar
Non-SFE Guru
Posts: 1927
Joined: Sun Nov 30, 2003 8:57 am
Location: Candia, NH

Return to PIC Microcontrollers - Software and Hardware

Who is online

Users browsing this forum: Google [Bot] and 5 guests