By LearningIsFun - Sun Aug 19, 2018 12:28 pm
- Sun Aug 19, 2018 12:28 pm #200081
I had some demo Easy Stepper code that could turn my stepper, and it is all hooked up correctly, but when I use my own code for full steps, I realized that they are 1/8 steps. How do I get full steps on an easy stepper? Low and Low on MS1 and MS2 says full, but they mean full micro steps, is there a way to get full steps on the motor, as the micro steps just cause a high pitched noise, and does not turn the stepper. I am new to this, so please be specific if you give me help, it will limit the amount of follow-up questions.