PulseIn stopped working
Posted: Fri May 11, 2018 11:46 am
Hello,
I’ve been using the code from SparkFun for the RC controller antweight robot. It was all working great. Now when I turn on the arduino the motors permanently stay on or jitter back and fourth.
When running the code through serial monitor instead of showing numbers been 900-2000ms it’s up anywhere from 5000-12000ms Every now and again it will show the vairables that it should be.
Also when there is only a wire plugged in it shows a pulse of 5000. This never used to happen.
Does anyone know why this has started to happen?
Thanks
Paul
I’ve been using the code from SparkFun for the RC controller antweight robot. It was all working great. Now when I turn on the arduino the motors permanently stay on or jitter back and fourth.
When running the code through serial monitor instead of showing numbers been 900-2000ms it’s up anywhere from 5000-12000ms Every now and again it will show the vairables that it should be.
Also when there is only a wire plugged in it shows a pulse of 5000. This never used to happen.
Does anyone know why this has started to happen?
Thanks
Paul