- Tue Jun 12, 2012 10:06 am
#145918
I've bought two zigbee modules from sparkfun: http://www.sparkfun.com/products/8665 and I want to connect these modules to my Arduino boards without using the shield.
Do I only need to connect VCC, GND, RX and TX pins which are present on the zigbee modules to my Arduinos or do I have to connect any additional wires?
In the datasheet, there is written that minimal connections are VCC, GND, DIN and DOUT.
Do I only need to connect VCC, GND, RX and TX pins which are present on the zigbee modules to my Arduinos or do I have to connect any additional wires?
In the datasheet, there is written that minimal connections are VCC, GND, DIN and DOUT.