- Fri Apr 29, 2011 9:53 pm
#126321
I just picked up two Pro Mini 3.3's and I'm getting errors as well when trying to upload through my FTDI board. My error is a little different:
I figured I would try the bootloader method but no dice. I set up my Uno and followed instructions to the letter. Here's the error I'm getting:
Code: Select all
I've seen this on my Duemilanove if, for example, I have the wrong board selected to upload to. Now, on several other posts people talked about a certain LED blinking sequence when the board was first powered on--i didn't have anything on mine, just a quick single blink of the green LED on power up (same as on reset). Maybe this is a clue? avrdude: stk500_recv(): programmer is not responding
I figured I would try the bootloader method but no dice. I set up my Uno and followed instructions to the letter. Here's the error I'm getting:
Code: Select all
The mini blinks a couple of times but that's about it. So if the bootloader can't event be set, what else can I do? Is it possible I really do have two bad boards? I've been playing with Arduinos for more than a year now so I'm pretty confident this isn't just a noob mistake. It's my first time using a Mini Pro, however. Anyone have any advice?avrdude: stk500_getparm(): (a) protocol error, expect=0x14, resp=0x14
avrdude: stk500_getparm(): (a) protocol error, expect=0x14, resp=0x01
avrdude: stk500_initialize(): (a) protocol error, expect=0x14, resp=0x10
avrdude: initialization failed, rc=-1
Double check connections and try again, or use -F to override
this check.
avrdude: stk500_disable(): unknown response=0x12