- Sun Jan 15, 2012 6:49 pm
#138294
Thank you
cbernett wrote:hello!I have the same problem. Were you able to find a solution?
i've gotten the WIFLY up and running at home with my airport express (WPA2), but am needing to transfer my whole setup to work, where I also have a secure WPA/WPA2 network, but am having trouble connecting to it. I'm using the library designed for it and it just hangs. so i thought i'd try your troubleshooting sketch, but am not able to get into command mode at all. in fact, following is what i see, with no response from the IDE when i enter $$$:
--------------------------------------
This is a tool to help you troubleshoot problems with the WiFly shield.
For consistent results unplug & replug power to your Arduino and WiFly shield.
(Ensure the serial monitor is not open when you remove power.)
Attempting to connect to SPI UART...
Connected to SPI UART.
* Use $$$ (with no line ending) to enter WiFly command mode. ("CMD")
* Then send each command followed by a carriage return.
Waiting for input.
WG÷·77÷·Ø@'÷7o¶Þw·@774Áç·`±·ßG·±yç¶6¶¡@g¶ Ƕ¡×0ÁWG÷·77÷·Ø@'÷7o¶Þw·@774Áç·`±·ßG·±yç¶6¶¡@g¶ Ƕ¡×0ÁWG÷·77÷·Ø@'÷7o¶Þw·@77¶Áç·`±·ßG·±yç¶6¶¡@g¶ Ƕ¡×0ÁWG÷·77÷·Ø@'÷7o¶Þw·@774Áç·`±·ßG·±yç¶6¶¡@g¶ Ƕ¡×0ÁWG÷·77÷·Ø@'÷7o¶Þw·@774Áç·`±·ßG·±yç¶6¶¡@g¶ Ƕ¡×0ÁWG÷·77÷·Ø@'÷7o¶Þw·@77¶Áç·`±·ßG·±yç¶6¶¡@g¶ Ƕ¡×0ÁWG÷·77÷·Ø@'÷7o¶Þw·@77¶Áç·`±·ßG·±yç¶6¶¡@g¶ Ƕ¡×0ÁWG÷·77÷·Ø@'÷7o¶Þw·@774Áç·`
This goes on for as long as I let it run. Any ideas?
Thank you so much!
c
Thank you