- Wed Jul 18, 2007 5:15 am
#32620
Hello,
I am designing a side repeater for a car and I need to design an LED mounted on a PCB that is facing rearward of the vehicle.
I am constrained in space and I am wondering how small I can make PCB.
The LED is an SMT OSRAM Power TOPLED LY E6SF.
They have a recommended solder pad design and it is about 6X6.1
Can I go down to an 8X10 or maybe even an 8x8?
TIA
Roacan
I am designing a side repeater for a car and I need to design an LED mounted on a PCB that is facing rearward of the vehicle.
I am constrained in space and I am wondering how small I can make PCB.
The LED is an SMT OSRAM Power TOPLED LY E6SF.
They have a recommended solder pad design and it is about 6X6.1
Can I go down to an 8X10 or maybe even an 8x8?
TIA
Roacan