- Sat Jun 30, 2007 3:41 pm
#32021
So I have seen a few people ask this question in the forum, but have not seen a definitive answer.....
What should you expect to see in your 3 preview files emailed back from BatchPCB?
My images look correct to me other than the fact the last image has no via holes. The 4 mount holes in the corners are there... as black holes but thats it. the components pads are all solid brown and so are the via's
For example bottom left I have two pads Vin and GND both are 1.4mm holed pads, but there are no holes. all the transistor and resistor pads are also solid..
Please advise.
What should you expect to see in your 3 preview files emailed back from BatchPCB?
My images look correct to me other than the fact the last image has no via holes. The 4 mount holes in the corners are there... as black holes but thats it. the components pads are all solid brown and so are the via's
For example bottom left I have two pads Vin and GND both are 1.4mm holed pads, but there are no holes. all the transistor and resistor pads are also solid..
Please advise.
Last edited by mhough on Sun Jul 01, 2007 12:12 pm, edited 1 time in total.