- Fri Jun 22, 2007 7:38 pm
#31730
This is my first attempts with BatchPCB.
I am using Sprint-Layout 5.0 and have not had any problems with my local board house.
When I receive the email after passing DRC, the bottom copper layer is solid copper. If I check it with View-Mate 9.6, it looks correct.
Any ideas?
Also, should I be seeing drill holes in the BatchPCB previews?
Thanks,
Craig
I am using Sprint-Layout 5.0 and have not had any problems with my local board house.
When I receive the email after passing DRC, the bottom copper layer is solid copper. If I check it with View-Mate 9.6, it looks correct.
Any ideas?
Also, should I be seeing drill holes in the BatchPCB previews?
Thanks,
Craig