SparkFun Forums 

Where electronics enthusiasts find answers.

Bottom copper layer solid but should not be

Questions relating to designing PCBs

Bottom copper layer solid but should not be

By Racer1
-  Fri Jun 22, 2007 7:38 pm #31730
This is my first attempts with BatchPCB.

I am using Sprint-Layout 5.0 and have not had any problems with my local board house.
When I receive the email after passing DRC, the bottom copper layer is solid copper. If I check it with View-Mate 9.6, it looks correct.

Any ideas?

Also, should I be seeing drill holes in the BatchPCB previews?

Thanks,
Craig
 Return to “PCB Design Questions”