PCB Copper Trace Finish
Posted: Sun Dec 23, 2018 3:28 am
Hi everyone,
I'm new pcb designer and I need your guidance.
I design a 4-layer board in Eagle and some of the traces will carry RF signals. I want the trace finish carrying the RF signals to be solder mask free and covered with gold finish as well as the pads that SMA connector is going to be soldered.
How can I declare this specification to the PCB manufacture?
Thanks in advance
I'm new pcb designer and I need your guidance.
I design a 4-layer board in Eagle and some of the traces will carry RF signals. I want the trace finish carrying the RF signals to be solder mask free and covered with gold finish as well as the pads that SMA connector is going to be soldered.
How can I declare this specification to the PCB manufacture?
Thanks in advance