SparkFun Forums 

Where electronics enthusiasts find answers.

Questions relating to designing PCBs
By icecool2
Hey SparkFun!

I'm getting back into designing my own PCBs again. I was surprised to see that Cadsoft was bought by Autodesk, but I see there is still a free version of Eagle.

I'm following the instructions from I installed Eagle and pulled down the ULP. I go to run it and the libraries seem to install, but then I get this error:
Can't open 'c:\EAGLE 9.2.\dru\SparkFun-2-layer-STANDARD.dru'
No such file or directory
I'm assuming this was supposed to be downloaded by the script, but maybe the script is out of date and the location changed?