- Mon Feb 06, 2017 4:35 pm
#193276
HI folks, I'm new to PCB design, sorry for the remedial question.
I downloaded an Eagle template from flyfish-tech.com, http://www.flyfish-tech.com/pub/RasPi-BplusHAT.zip and was able to paste the image fine on my board (brd) surface.
However it is just a single image of a board, and there are no active symbols on the board drawing to anchor routes to.
Am I supposed to just drop a connector and my components to visually align with this image, then remove the template image? Or do I some how connect routes to the connector images on the template?
Thanks
-John
I downloaded an Eagle template from flyfish-tech.com, http://www.flyfish-tech.com/pub/RasPi-BplusHAT.zip and was able to paste the image fine on my board (brd) surface.
However it is just a single image of a board, and there are no active symbols on the board drawing to anchor routes to.
Am I supposed to just drop a connector and my components to visually align with this image, then remove the template image? Or do I some how connect routes to the connector images on the template?
Thanks
-John