Can Someone Check An Eagle Board Please?
Posted: Tue Sep 20, 2016 4:20 am
Hey all!
I've used Eagle CAD along with the info in the Sparkfun tutorials to draw up my first circuit board and I'd like to have someone with more experience take a look at it for me. This way I can ensure everything is correct before I send it for printing and I don't end up with coasters!
I'm stuck on the actual board, looking at the air wires it looks like the outputs from V-Regs are tied together when they are separate, I've tried to fix it but I cannot.
The circuit in question is for voltage regulation for a rather large set of LEDs. It's using Sharp LDO Voltage Regulators with a .33uf Tantalum capacitor across the voltage input pin and ground (pins 1 and 3) and 47uf Electrolytic capacitor across the voltage output pin and ground (pins 2 and 3). I am not using pin 4 on the voltage regulators.
Here's a link to download it from Drive: https://drive.google.com/open?id=0B8rzf ... kxEaU9XX0k
I've used Eagle CAD along with the info in the Sparkfun tutorials to draw up my first circuit board and I'd like to have someone with more experience take a look at it for me. This way I can ensure everything is correct before I send it for printing and I don't end up with coasters!
I'm stuck on the actual board, looking at the air wires it looks like the outputs from V-Regs are tied together when they are separate, I've tried to fix it but I cannot.
The circuit in question is for voltage regulation for a rather large set of LEDs. It's using Sharp LDO Voltage Regulators with a .33uf Tantalum capacitor across the voltage input pin and ground (pins 1 and 3) and 47uf Electrolytic capacitor across the voltage output pin and ground (pins 2 and 3). I am not using pin 4 on the voltage regulators.
Here's a link to download it from Drive: https://drive.google.com/open?id=0B8rzf ... kxEaU9XX0k