- Fri Jul 01, 2016 3:06 am
#190461
Hi all,
I am new to PCB designing and I am using Orcad 9.2 version. I am confused with the layer stacking. In the software, layers are in the order TOP, BOTTOM, GND, POWER, IN1, IN2,... . If I have to make a stack like TOP, GND1, POWER1, POWER2, GND2 AND BOTTOM, then shall I mention layers in the spreadsheet in the same way or it will arrange itself?
I am new to PCB designing and I am using Orcad 9.2 version. I am confused with the layer stacking. In the software, layers are in the order TOP, BOTTOM, GND, POWER, IN1, IN2,... . If I have to make a stack like TOP, GND1, POWER1, POWER2, GND2 AND BOTTOM, then shall I mention layers in the spreadsheet in the same way or it will arrange itself?