- Thu Jan 28, 2016 9:07 am
#187673
How do I specify a non-rectangular board outline in the Gerber files from Eagle.
I know the board outline is in the 20 dimension layer -- but there seems no output fine in the sfe-gerber274x.cam definitions.
I tried submitting the .brd through oshpark - and they seemed to show a rectangular board.
Thoughts?
Jim
I know the board outline is in the 20 dimension layer -- but there seems no output fine in the sfe-gerber274x.cam definitions.
I tried submitting the .brd through oshpark - and they seemed to show a rectangular board.
Thoughts?
Jim