SparkFun Forums 

Where electronics enthusiasts find answers.

Questions relating to designing PCBs
By Daemach
#184861
I created a part in Eagle by following the tutorial. For some reason, I cannot get it to connect to any nets. Clearly I've done something wrong but I can't figure out what... I stuck with standard grid spacing when I created the symbol.

I've attached the schematic file to this post. If you can help me figure this out I would really appreciate it!
IAQCore.zip
You do not have the required permissions to view the files attached to this post.
By uChip
#184868
You have the pins turned around backwards. Swap them end for end.

- Chip