- Thu May 07, 2015 12:28 pm
#181831
Hi All,
I'm designing a PCB with Eagle 6.4 to go in a Hammond 1593L enclosure, and I need to make four notches around the periphery of the board outline to provide clearance for the cover mounting bosses/screws. I've been wrestling with this for a couple of hours, and I've yet to come up with a fool proof method to add notches of a specific width/depth/radius at specific locations on my board outline. Any tips?
John
I'm designing a PCB with Eagle 6.4 to go in a Hammond 1593L enclosure, and I need to make four notches around the periphery of the board outline to provide clearance for the cover mounting bosses/screws. I've been wrestling with this for a couple of hours, and I've yet to come up with a fool proof method to add notches of a specific width/depth/radius at specific locations on my board outline. Any tips?
John