- Wed Apr 15, 2015 11:35 am
#181243
I am trying to prepare a circuit for printing at a manufacturer; ShenZhen2U, for the first time. But, a stray island is appearing on the bottom layer of the board.
Here has been the procedure:
I downloaded and installed theShenZhen2U EAGLE Design Rules.
I loaded them into the DRC.
Before I run the DRC, the stray island does not show up.
After I run the DRC, the stray island appears.
The following functions do not remove the island:
Trash Can
Rip-Up
Redraw
Ratsnest
Orphans = Off
I have done my "homework" and have not come across the answer. So, I would appreciate your help with removing the stray island. I would also like to know if I may ignore the stop mask errors. Any other general suggestions would also be welcomed.
Thank you for your help.
Here has been the procedure:
I downloaded and installed theShenZhen2U EAGLE Design Rules.
I loaded them into the DRC.
Before I run the DRC, the stray island does not show up.
After I run the DRC, the stray island appears.
The following functions do not remove the island:
Trash Can
Rip-Up
Redraw
Ratsnest
Orphans = Off
I have done my "homework" and have not come across the answer. So, I would appreciate your help with removing the stray island. I would also like to know if I may ignore the stop mask errors. Any other general suggestions would also be welcomed.
Thank you for your help.
Last edited by t1d on Wed Apr 15, 2015 5:37 pm, edited 2 times in total.