- Wed Jan 28, 2015 3:44 pm
#179196
Hi, I'm new to Eagle. I have created a PCB (from scratch, ie not from a schematic), but now I want to rearrange some elements. To facilitate this task, I want to use the "group" command. However, when I try to group a set of elements, the command doesn't "pick up" all the elements even though they are all completely and entirely inside the grey "group" rectangle. After the attempted grouping, when I do a "move", only some of the "grouped" elements actually move, while others don't. Does this ring a bell to anybody? What could be the issue? Read a lot of Eagle related stuff online, but couldn't find an answer. Thanks in advance. Mario