SparkFun Forums 

Where electronics enthusiasts find answers.

Questions relating to designing PCBs
By mikepap
#171962
Hello my friends,
I have a schematic of a project and I would like to turn it into a board but sadly I can't...thus I would like some help from you! It's not complicated at all and the board is only 12x12 (two layer).
If someone is willing to help me please reply and I will email you or PM you the schematic!

Thanks again and have a nice day,
Jim
User avatar
By Ross Robotics
#172059
It's millimeter. I have been in contact with Mike and I must admit that his goals are far fetched. The board is tiny.
User avatar
By Ross Robotics
#172063
It's a switching regulator circuit. I haven't started on the board yet, but the parts are 0201- 0805. So it might be possible.. Not many parts either..