SparkFun Forums

Where electronics enthusiasts find answers.

Grab the edge/center of a group in Eagle for panelization?#169323

By PenComp7 - Thu Mar 13, 2014 8:12 am

- Thu Mar 13, 2014 8:12 am #169323

Typically when you want to grab the center of a component you can press Ctrl+left click, this will snap to your grid. Is there a way to do this for a group of components? I am trying to panelize a board and have copied in the second board, but I can't get the copied board to lineup with my grids. Thanks.

Re: Grab the edge/center of a group in Eagle for panelizatio#169324

By Ross Robotics - Thu Mar 13, 2014 8:59 am

- Thu Mar 13, 2014 8:59 am #169324

Why don't you use the panelize ULP script?

------------------------------------------------------------------------------------------------------------------------------------------------------------
//codlink
Available for circuit and PCB design, just PM me!

Re: Grab the edge/center of a group in Eagle for panelizatio#169331

By PenComp7 - Thu Mar 13, 2014 10:10 am

- Thu Mar 13, 2014 10:10 am #169331

Thanks for the quick reply and I could be wrong, but the ULP script seems to be for naming under a panel setup. I think I found a solution: you have to copy and paste from within the same board for the grid system to attach. So I copy a new board in, then copy the board again and the native grid system seems to be working.

Page 1 of 1
3 posts

Return to “PCB Design Questions”