SparkFun Forums 

Where electronics enthusiasts find answers.

PCB circuit problem

Questions relating to designing PCBs

Re: PCB circuit problem

By neuro11
-  Tue Mar 18, 2014 5:33 am #169503
I could not find any option in ultiboard about changing the circular antipad to square. But in the power plane properties I could change clearance of antipad to pad. So I did that. now they are not overlapping with square pad but they are overlapping each other...do you think that's a problem???
You do not have the required permissions to view the files attached to this post.

Re: PCB circuit problem

By n1ist
-  Wed Mar 19, 2014 6:09 am #169545
The ground-plane slots should not be an issue with this board. Pin 1 of the IC, however, still looks like it is shorted to the plane.
/mike

Re: PCB circuit problem

By neuro11
-  Wed Mar 19, 2014 7:33 am #169547
n1ist wrote:The ground-plane slots should not be an issue with this board. Pin 1 of the IC, however, still looks like it is shorted to the plane.
/mike
No I have zoomed and checked its fine.
Thanks for your helpful feedback....
 Return to “PCB Design Questions”