SparkFun Forums 

Where electronics enthusiasts find answers.

Questions relating to designing PCBs
By Muris
#53839
Hi,

Does anyone have a PCB layout of Nokia's 1100 phone? Just the border.

I want to make new guts for this phone to do something else...

If not, is there any method of drawing these non-square shapes in Eagle PCB?

Thanks :)
By Andrew02E
#53869
You are not restricted to square board shapes in Eagle. Select a layer for your board outline (ie. Dimension) or create a layer for it. In that layer, draw whatever board outline you want using the line, arc, etc. tools (that's easier said than done, though). Try to make sure that all adjacent lines/arcs have their endpoints on the same coordinates.
By Muris
#53877
Thanks for the tip. I will do that, if I don't find this layout somewhere.
By StandardPCB
#54040
Hi, Muris

any interest in sample fabrication? we can provide service.

RIPPLE