Interfacing with custom processor

Open source ARM Debugger

Moderator: phalanx

Post Reply
MateoConLechuga
Posts: 1
Joined: Wed Jul 25, 2018 2:55 pm

Interfacing with custom processor

Post by MateoConLechuga » Wed Jul 25, 2018 2:57 pm

Hello everyone! I have a custom 3rd-party processor with a TAP debug interface via jtag. I am wondering what would be required to be able to support OpenOCD in tandem with GDB and interfacing to the on-chip TAP? Currently the processor is instantiated on a KC705 FPGA. Any advice would be much appreciated. Thanks!

Post Reply