SparkFun Forums 

Where electronics enthusiasts find answers.

Open source ARM Debugger
Hi all,

Sorry for my ignorance as a beginner in the world of JTAG, I have some S3C2440 chips to write the bootloader (some kb in size) and I would like to use some other card I already have to serve as interface,

I have Arduino Nano / Mega / Due and STM32F103C8T6.

Does anyone know if it is possible to use some of these cards as an interface,

So I can program the S3C2440?

Any tutorial on how to do this?

Thank you!

I think your alternative is very interesting,

However I have already managed to solve my problem,

With the help of a small Wiggler parallel port interface (SN74HC244) in conjunction with H-Jtag sorfware v3.0. I was able to program the SuperVivi bootloader, so with a serial cable and a USB cable the bootloader gave me the option to backup through the DNW.exe program.

My board is a old Mini2440 FriendlyArm.

Thank you for your attention!
By rtek
Note: I have not found the title editing option, I would like to add [Solved], how can I do it?