- Sun Jan 15, 2017 12:17 pm
#192923
I'm trying to program a: http://aconno.de/wp-content/uploads/201 ... -Sheet.pdf
using this arduino core: https://github.com/sandeepmistry/arduino-nRF5
for this I got a genuine st-link v2: http://uk.rs-online.com/web/p/entwicklu ... r/7141701/
with this driver from the OEM website: en.stsw-link009.zip
Unfortunately it does not work, the device is listed in the windows device manger but when i try to upload a sketch or the soft device it fails to connect:
Any ideas what I could be doing wrong?
using this arduino core: https://github.com/sandeepmistry/arduino-nRF5
for this I got a genuine st-link v2: http://uk.rs-online.com/web/p/entwicklu ... r/7141701/
with this driver from the OEM website: en.stsw-link009.zip
Unfortunately it does not work, the device is listed in the windows device manger but when i try to upload a sketch or the soft device it fails to connect:
Code: Select all
the programmer does not blink the led just stays red, so there must be come communication issue...Sketch uses 2,520 bytes (0%) of program storage space. Maximum is 409,600 bytes.
Open On-Chip Debugger 0.10.0-dev-00254-g696fc0a (2016-04-10-10:13)
Licensed under GNU GPL v2
For bug reports, read
http://openocd.org/doc/doxygen/bugs.html
debug_level: 0
0x4000
adapter speed: 10000 kHz
Error: open failed
in procedure 'program'
in procedure 'init' called at file "embedded:startup.tcl", line 473
in procedure 'ocd_bouncer'
** OpenOCD init failed **
shutdown command invoked
the selected serial port
does not exist or your board is not connected
Any ideas what I could be doing wrong?