SparkFun Forums

[mifi]

Hello,

sometimes Eclipse hat a problem after downloading
the source to the Ethernut3. I found that the problem
was my last debugger command "continue".

Now I have removed it, and it woks better. The debugger commands
looks now:

target remote localhost:3333
monitor reset
monitor sleep 500
monitor poll
monitor soft_reset_halt
monitor arm7_9 sw_bkpts enable
monitor mww 0xFFE00000 0x1000213D
monitor mww 0xFFE00004 0x20003E3D
monitor mww 0xFFE00020 0x00000001
monitor mdw 0xFFE00000 1
monitor mdw 0xFFE00004 1
break NutAppMain
load

Best regards,

Michael

[Martin Ludwig]

hello michael,

i´ve tested this too with insight, but it doesn´t solve my problems.
even if i add continue i can debug for a little while.

i´ve send the debug outputs from openocd to dominic - hope he founds a solution

martin