SparkFun Forums 

Where electronics enthusiasts find answers.

Open source ARM Debugger
By naz
hello all ,
we are using ARM-Jtag,I'm getting the following error after installation
[root@my ~]# openocd
Open On-Chip Debugger 0.4.0 (2010-02-22-22:58)
Licensed under GNU GPL v2
For bug reports, read
parport port = 0x378
RCLK - adaptive
jtag_nsrst_delay: 200
jtag_ntrst_delay: 200
trst_and_srst srst_pulls_trst srst_gates_jtag trst_push_pull srst_open_drain
Error: cannot open device. check it exists and that user read and write rights are set. errno=2
Command handler execution failed

any one can guide me for this issue.