SparkFun Forums 

Where electronics enthusiasts find answers.

Have questions about SparkFun's ALC PCB design services? Post them here!
User avatar
By gDFfRc7VvzfYydHP
#222205
Would it be possible to allow moving components at bit around by hand? For example, if I put an IMU with a magnetometer, I want to move it to the edge of the board, to be away from where currents / RF modules / batteries will be located. Translation X and Y directions would be enough, i.e. only "stretching" wires in a sense.
 Topic permissions

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum