SparkFun Forums 

Where electronics enthusiasts find answers.

Hardware or product specific questions are best asked here.
User avatar
By matialvarezs
Hi, you bought the LMV358 board (, but I have a doubt on how to configure it for the 100KHz sea output

The description reads: "... The bandwidth is set to 15.9kHz by a pair of feedback capacitors, or over 100kHz with the caps removed ....",

My question is this: how do I remove the caps?

I would like to see an image with the caps removed.

Thank you very much for your help.

Stay tuned to any comments


Matias Alvarez Sabate
User avatar
By TS-Chris
Hello matialvarezs.

I don't have a photo with the capacitors removed, but the picture below show which ones need to be removed.
You would need to desolder them from the board to remove them.
You do not have the required permissions to view the files attached to this post.
 Topic permissions

You can post new topics in this forum
You can reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum