SparkFun Forums 

Where electronics enthusiasts find answers.

Tips and questions relating to the GPS modules from SFE
By fgcity
Hi guys. I have a litle problem

I am sending the GPS NMEA data from the ET 301 through a nRF 2401 to a development nRF2401 module

The thing is that i am recieving the data from the GPS on 4800 and am sending it to the Development board and reading the signal with 9600

So i am getting allot of garbage on the NRF reciever end.

If i put a direct line from the GPS module then the signal goes to the Terminal of a PC fine.

So what is the problem here?
By fgcity
heh, i'm kinda solving my own problems here :)

it was a wrong setting on the XTAL of the PIC :)