- Wed Jun 06, 2007 9:23 am
#30946
In the Specification table of the EB-85A datasheet, "Mounting" is indicated as being "Soldering".
However, the pictures don't seem to show solder tabs and there is no footprint indicated in either the datasheet or the user manual.
There are no apparent mounting holes either.
Perhaps there is a right angle connector that might fit into the 8-pin connector, but that would only secure the part from one edge; it wouldn't seem to be a mechanically sound solution.
So, how would one securely fasten the EB-85A into a product?
However, the pictures don't seem to show solder tabs and there is no footprint indicated in either the datasheet or the user manual.
There are no apparent mounting holes either.
Perhaps there is a right angle connector that might fit into the 8-pin connector, but that would only secure the part from one edge; it wouldn't seem to be a mechanically sound solution.
So, how would one securely fasten the EB-85A into a product?