SparkFun Forums 

Where electronics enthusiasts find answers.

Tips and questions relating to the GPS modules from SFE
By afreyer
#65726
I literally have no idea how this is possible, but it appears as though I have sent some mode programming strings to the minimod; currently it is outputting only $GPGGA - nothing more.

I am using an Arduino Nano with 0012.

I have been experimenting with code I have found online, and I recall that one block had programming functions (to limit which NMEA strings were output), and I may have run that function, but I definitely declared pin 2 (software serial) as an input, so I cannot see how, even if I sent the codes by mistake, how the arduino would have allowed it.

In any case, I would like to know how to reprogram this thing to get all of the strings back again.

I can't seem to find documentation regarding these modes on the MiniMod.
By gm
#65732
I found this on the micro modular site.

Hope this helps!

gm