SparkFun Forums 

Where electronics enthusiasts find answers.

Questions about the BatchPCB service

Moderator: robacarp

By BigJP
#3807
I am trying to print my board in protel, but every time i do this it prints full page. Is there anyway to get protel to print the board in the boards actual dimensions?

Thanks
User avatar
By sparky
#3826
Yea - File->Page Setup

There is a section called Scaling. Set this 'Scaled Print' with a scale of 1.00.

-Nathan
By BigJP
#3862
very nice now how do you save a jpg of the board

Sorry should of asked all at once
By Caffeine
#3866
BigJP wrote:very nice now how do you save a jpg of the board

Sorry should of asked all at once
File -> export -> Bitmap :) use an image converter (mspaint even) to convert to jpg
By BigJP
#3879
Thanks, I tried to find export before i asked, but i must be blind i will look again at home